weberdry seal
Packaging: 1 kg, 4 kg and 20 kg/drum
Color: White, Grey
Ready-to-use SUPER FLEXIBLE acrylic waterproof membrane weberdry seal
Feature:
- Highly flexible
- Cover cracks
- Good adhesion on many material surfaces
- Waterproofing for terrace, rooftops and external walls
- Resists the growth of mold, moss
- UV resistance, heat reflection
- Low VOCs
Application:
- For walls, bathroom areas, kitchens, balconies, specially in the elevated position of high-rise buildings when subjected to vibration
- For concrete or surface surfaces with high vibrations such as gypsum, fiber cement sheets
- Waterproofing for roof areas, outer walls, surfaces finishes
- Exterior paint reflecting light
- Flexible
- Bao phủ các vết nứt
- Tránh hiện tượng rỉ nước từ các mối nối
- Chống thấm dột từ mái nhà, tầng mái và tường
- Anti-fungal
- UV reflection
- Approved for Low VOCs - safe for the health of consumers
- Bám dính tốt trên nhiều bề mặt vật liệu
Colors
Indicator | Standard | weberdry seal |
|---|---|---|
| Consumption* | Exposed roof: ~ 1.5 - 2.0 kg/m2 Covered Terrace: ~ 1.0 kg/m2 Use as exterior wall paint: ~ 0.4 – 0.5 kg/m2 | |
| Density | 1.49 g/cm3 | |
| Soilids content | 75 ± 2% | |
| Elongation | D638 | 400% |
| Crack bridging capability |
| ~ 2 mm |
| Waterproofing | EN 14891 | Impervious |
| Adhesion strength | EN 14891 - A.6.2:2007 | > 1 N/mm2 |
| Adhesion strength after heating | EN 14891 - A.6.5:2007 | > 1 N/mm2 |
| Adhesion strength after exposed to hard water | EN 14891 – A.6.9:2007 | > 1 N/mm2 |
*Remark: These technical data and test results are from laboratory test. They could be different from in-situ results due to the differences in application and conditions.
- High elasticity
- Covers cracks well
- Resistant to the growth of moss and mold
- Good resistance to UV rays and heat reflection
- Meets Low VOCs standards - safe for consumers' health
- Good adhesion to various material surfaces.
- Applied 1st coat of weberdry seal on the joints to cover at least 10cm on both side. Place webertape BE 14 on the joints and make sure there are no bubbles below. Wait for 4 – 6 hours to let 1st coat dries, and apply 2nd coat to cover the tape
- Surface drying time: 2 hours
- Construction time applied between layers: 4 - 6 hours
- Time to wait before tiling: 48 hours
- Should implement the details and points of the previous corner, then the construction applied on the entire surface.
- The pre-mixed weberdry seal, just stir thoroughly before use.
- Do not mix weberdry seal with water unless used as a primer
- Limit construction directly in the sun or on surfaces that are too hot or too cold
Tutorials and videos
Case studies
